Kenwood VR-510 User Manual - Page 50

In case of difficulty Remote control unit 50 Symptom The battery indicator flashes during operation. Subwoofer volume cannot be adjusted. Certain inputs cannot be selected using the remote control. Remote control operation is not possible. Cause Remedy • The batteries are nearing exhaustion. • Replace with new batteries to preserve the currently registered setup information. ( • Subwoofer is OFF. • Turn the subwoofer ON. ™ • No setup codes registered at for the respective • Register a setup code or Non-IR code at the input(s). respective input(s). fl • The remote control is set to a different operation mode. • Batteries are exhausted. • The remote control unit is too far away from the main system, controlling angle is too large, or there is an obstacle between the receiver and the remote. • The audio cords and system control cords are not connected properly. • No software is loaded in the source component. • An attempt is made to play a tape which is being recorded in the cassette deck. • The remote control has not been set to the operation mode for the component you wish to control. • The microprocessor of the remote control malfunctions. • Press the MUSIC, MOVIE, or TV keys to select the appropriate operation mode. • Replace with new batteries. ( • Operate the remote control unit within the con- trollable range. • Connect properly referring to "Setting up the system". 7 • Place software in the source component you want to play. • Wait until recording has completed. • Press the MUSIC, MOVIE, or TV keys to acti- vate the operation mode for the component you want to control before operation. ¡ • Reset the microprocessor. o Additional Information