Kenwood WD250 Instruction Manual - Page 6
Troubleshooting, Guide, Specifications
UPC - 019048160652
View all Kenwood WD250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Troubleshooting Guide Often, what appears to be a malfunctionis due to user error. Before calling for service,please consult the following table. Oroblem Cause • The fuse is blown. Remedy • Check the (+)/(-) polarity of the power cord and that the cords are not shorted, then replace with a fuse with the rated capacity. • Re-connect the cords correctly by referring to the connection example (on page 4). • The power supply pin (yellow) of the 10-pin connection cord is Power cannot be turned on not connected. (the POWER indicator does • The power control pin (blue) of the 10-pin connection cord is not light). not connected. • The 10-pin connector is not plugged in completely. • The grounding pin (black) of the 10-pin connection cord is not connected. • Connect the cord correctly by referring to the connection example (on page 4). • Check the connections of all cords, then connect the (-) cable to the battery. • Insert the connector all the way in. • Attach the grounding terminal to the metallic section of the vehicle (not a coated surface) by tightly screwing it. • The negative (-) cable of the car battery is disconnected. • Check the connections of all cords, then connect the (-) cable to the battery. • The attenuator of the center unit is set to ON. • Switch the attenuator OFF. No sound • The LEVEL control is set to the MIN position. • The speaker cords are connected improperly. • Increase the volume to an optimum level. • Connect the cords correclty by referring to the connection example (on page 4). Sound quality is bad (sound is distorted). • Connection terminals are connected improperly. • The LEVEL control is set to the MAX position. • Insert the connectors or jacks all the way in to the terminals. • Set the volume to an optimum level. Unable control • Remote control cord is not connected. • Connect remote control cord to remote control terminal. The sound is unnatural. • The speaker cords are connected with incorrect positive (+)/ negative (-) polarity. • The grounding pin (black) of the 10-pin connection cord is poorly contacted. • Connect the cords correctly by referring to the connection example (on page 4). • Attach the grounding terminal to the metallic section of the vehicle (not a coated surface) by tightly screwing it. Specifications The followingratings anddesign are subject to change withoutnotice. [Amp unit] Maximum output Frequency Response (System) S/N ratio Low Pass Filter Frequency Phase Sensitivity/ Input Impedance (RCA pin jack) (Speaker input) Power Maximum current consumption Fuse capacity External size Weight 200W 30 - 150Hz 85dB 50Hz, 80Hz, 100Hz, 150Hz (4 steps) 0°, 180° 210mV / 10kO 4.2V / 1kO DC14.4V (Operational range 10.5 - 16V) 10A 5A x 2 Width 195mm x height 30mm x depth 155mm (7-11/16"x 1-3/16"x 6-1/8") 800g (1.81b) [Speaker unit] Impedance Woofer (1.5 O + 1.5 O) = 0.75 10 inch Cone type [Amp unit] + [Speaker unit] Net weight External size 11.5kg (25.4 Ib) Width 353mm x height 327.5mm x depth 371.7mm (13-7/8" x 12-7/8"x 14-5/8") 6 English