Kenwood XR-1S Owner's Manual (pdf) - Page 9

* Commercially available parts ■ Multi Amplifier with Remote cable connection (Accessory of KAC-X1D, Optional accessory for XR-1S.) CAUTION • Before connecting the remote controller cables, always turn the Bass boost level knob all the way to the left. You can control the Bass boost level of the second and subsequent Slave amplifiers simultaneously from the Master amplifier. The volume level of each amplifier is determined by the setting of the Master amplifier (INPUT SENSITIVITY, boost level of the remote controller). Setting the Master amplifier 1. Adjust the INPUT SENSIVITY to the output of the center unit to be connected. 2. Set the LPF frequency and ISF. 3. Turn the LINE OUT FILTER switch ON. Setting the Slave amplifier 1. Turn the LINE OUT FILTER switch OFF. 2. Adjust the INPUT SENSIVITY. • To adjust the Slave amplifier to the same volume as the Master amplifier, adjust the INPUT SENSIVITY to 0.2 V (max.). Remote cable CENTER UNIT (CD receiver, etc.) RCA cable* Power control wire* Remote controller FUSE [30Ax2] BATT. GND P.CON Master amplifier SPEAKER OUTPUT REMOTE LINE IN LINE OUT L R LINE OUT FILTER OFF ON 2 3 4 [MIN] 5 1 0.5 0.3 0.2 [MAX] Extension wire* RCA cable* FUSE [30Ax2] BATT. GND P.CON Slave amplifier SPEAKER OUTPUT Hexagon Wrench (Small) Use the attached FUSE [30Ax2] Hexagon Wrench. BATT. GND P.CON Slave amplifier SPEAKER OUTPUT REMOTE LINE IN LINE OUT L R REMOTE LINE IN LINE OUT L R LINE OUT FILTER OFF ON 2 3 4 [MIN] 5 1 0.5 0.3 0.2 [MAX] LINE OUT FILTER OFF ON 2 3 4 [MIN] 5 1 0.5 0.3 0.2 [MAX] English