KitchenAid KBFN502EPA Installation Guide - Page 17
Notes
View all KitchenAid KBFN502EPA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Door Panels for Dispenser Models The freezer panel should not weigh more than 40 lbs (18.1 kg). The refrigerator panel should not weigh more than 50 lbs (23 kg). A B ¹⁄₂" (1.27 cm) ¹⁄₄" thick plywood Freezer Door (Dispenser) Refrigerator Door ¹⁄₂" (1.27 cm) Dispenser Frame (Classic series dispenser models) The dispenser frame attaches to the panel with 4 screws. To remove the dispenser frame: 1. Remove the four screws attaching the frame. 2. Pull the dispenser frame from the decorative panel. 3. To replace the frame, hold the frame to the panel and replace the screws. 14¹⁄₄" (36.2 cm) 10⁷⁄₈" (27.6 cm) 70 178.9 cm) 1.1 cm) Dispenser cutout is ¹⁄₄" thick plywood centered left-to-right 3¹⁄₄" 33³⁄₄" (8.3 cm) (85.7 cm) 3¹⁄₄" A (8.3 cm) 1.1 cm) Model 36 42 48 ¹⁄₂" Location and offsets (1.27 cm) of raised wood panel ¹⁄₂" (1.27 cm) A B 14¹⁄₄" (36.2 cm) 19¹⁄₄" (48.9 cm) 16³⁄₄" (42.6 cm) 22³⁄₄" (57.8 cm) 19¹⁄₄" (48.9 cm) 26¹⁄₄" (66.7 cm) NOTES: ■ Dispenser cutout is centered left-to-right. ■ If the standard handle is used, the handle side offset of both panels should be 3¹⁄₄" (8.25 cm) to all for finger clearance. ■ If an extended handle is used, the handle side offset of both panels should be 1.1 cm). Make sure the refrigerator location allows the doors with extended handles to open to 90 degrees. See "Door Swing Dimensions." ■ The dashed lines in the illustration represent the location and offsets of raised wood panel. A. Dispenser frame The dispenser frame overlaps the dispenser cutout by 0.78 cm) on each side and ¹⁄₂" (1.27 cm) on the top and bottom. A A A 1.27 cm) Overlap 17