KitchenAid KBMS1454SSS Installation Guide - Page 2

INSTALLATION REQUIREMENTS Tools and Parts Tools Needed Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. s Measuring tape s Pencil s T10 TORX®† screwdriver s Electric drill s 5/64" (2 mm) drill bit Parts Supplied All of the following parts are provided, but not all parts will be used. The cutout opening size will determine which parts you will use. See chart below parts list to see which parts are used for each installation. A C B Location Requirements The microwave oven may be located in a cabinet, and/or above a built-in oven, or below the counter and/or below a non-vented cooktop. Check the opening where the microwave oven will be installed. The location must provide: s Wood cabinetry. s Cutout opening that is plumb and square. See "Minimum Cutout Dimensions" in "Minimum Dimensions" section. s Cutout floor that is solid, level and flush with bottom of cabinet cutout. s Support for weight of at least 150 lbs (68 kg), which includes microwave oven and items placed inside. s Grounded electrical outlet. See "Electrical Requirements" section. s Minimum installation clearances for installation location. See "Minimum Dimensions" section. We recommend: s Complete enclosure around the recessed portion of the microwave oven. D E A. Side brackets (2) B. Removable extension plates (shaded piece, 2) C. 1" T-10 screws (6) D. Narrow side trim panels (2) E. Wide side trim panels (2) INSTALLATION PARTS USED 24" (61.0 cm) installation C 27" (68.6 cm) installation* A, C, D 30" (76.2 cm) installation A, B, C, E *Extension plate (B) will have to be removed from side bracket (A) for this installation. †®TORX is a registered trademark of Textron Innovations Inc. 2