KitchenAid KBNU271VSS Use & Care Guide - Page 18
Gas Conversions - burner parts
View all KitchenAid KBNU271VSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
4. Gently slide the grill completely into the outdoor enclosure. WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. ■ Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts. ■ Do not operate any outdoor cooking gas appliance with a damaged cord, damaged plug, or after the appliance malfunctions or has been damaged in any manner. Contact the manufacturer for repair. ■ Do not let the cord hang over the edge of a table or touch hot surfaces. ■ Do not use an outdoor cooking appliance for purposes other than intended. ■ When connecting, first connect plug to the outdoor cooking gas appliance then plug appliance into the outlet. ■ Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance. ■ Do not remove the ground prong or use with an adapter of 2 prongs. 6. Go to the "Check and Adjust the Burners" section. 5. Plug 3-prong power cord plug into a grounded 3-prong GFI outlet. ■ To avoid electrical shock, do not immerse cord or plugs in water or other liquid. GAS CONVERSIONS For Models Equipped for Use with a 20 lb LP gas Tank NOTES: ■ Models that are equipped for Natural gas require Gas Conversion Kit Part Number W10118099 for conversion to LP gas. Use the conversion instructions included in the kit. See "Assistance or Service" section for information on ordering. This kit is designed for use from sea level up to 2000 ft elevation. For higher elevations contact KitchenAid at 1-800-422-1230 in the U.S.A. or call 1-800-607-6777 in Canada. WARNING ■ The Fuel Remaining feature of the electronic grill display does not function with grills that are converted to Local LP (fixed piped) or Natural gas. Tools and Parts for Gas Conversion Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed ■ Phillips screwdriver ■ Pipe wrench ■ Adjustable wrench ■ 6 mm socket and wrench or 6 mm nut driver ■ 10 mm wrench ■ Thin flat-blade screwdriver ■ Pliers ■ Pipe thread sealant certified for LP gas Parts supplied ■ Brass connector ■ Convertible regulator 4" W.C. Natural, 11" W.C. LP ■ Natural gas orifices IMPORTANT: Gas conversions must be done by a qualified installer. Before proceeding with conversion, shut off the gas supply to the appliance prior to disconnecting the electrical power. Explosion Hazard Use a new CSA International approved "outdoor" gas supply line. Securely tighten all gas connections. If connected to LP, have a qualified person make sure gas pressure does not exceed 11" (28 cm) water column. Examples of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Failure to do so can result in death, explosion, or fire. 18