KitchenAid KCMS1655BSS Installation Guide - Page 3
Grounding Instructions, Save These Instructions - microwave
View all KitchenAid KCMS1655BSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Electrical Requirements WARNING Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. Observe all governing codes and ordinances. Required: ■ A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply with a fuse or circuit breaker. Recommended: ■ A time-delay fuse or time-delay circuit breaker. ■ A separate circuit serving only this microwave oven. GROUNDING INSTRUCTIONS ■ For all cord connected appliances: The microwave oven must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. The microwave oven is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. WARNING: Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if doubt exists as to whether the microwave oven is properly grounded. Do not use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman install an outlet near the microwave oven. SAVE THESE INSTRUCTIONS Prepare Microwave Oven 1. Unplug microwave oven before proceeding with installation. 2. Remove any loose items inside microwave oven. 3. Gently turn microwave oven onto its top, with the door facing forward (toward installer). 4. Align the two rails on the microwave oven bottom, as shown, making sure the flanges are forward and pointing up. A B C D E A. Rails (2) B. Microwave oven bottom C. Short screws (4) D. Flanges E. Door 5. Secure the rails to the microwave oven bottom using four short screws. Prepare Cutout/Cabinet Opening 1. On the cutout floor, find and mark the centerline. 2. Place the bottom duct in the opening, with the flange resting against the bottom front facing of the opening. A B C D A. Cutout floor B. Centerline C. Bottom duct E D. Bottom duct flange E. Front facing 3