KitchenAid KDFE104HBL Owners Manual - Page 10
Start, Cancel, Hi-Temp
View all KitchenAid KDFE104HBL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
CONTROLS AND CYCLE STATUS Control Start RESUME Cancel Drain Hi-Temp Wash Sound on/Off Hold 3 Sec Purpose To start or resume a wash cycle. Comments If the door is opened during a cycle or the power is interrupted, the Start/RESUME indicator flashes. To cancel a wash cycle after it has been started To turn the audible tones on or off. Close the door firmly. Touch and hold Cancel/DRAIN for 3 seconds. The dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely. Touch and hold Hi-Temp Wash for 3 seconds to turn the audible tones on or off. Only audible tones for confirming keypad touches can be turned on/off. Important audible tones, such as indicating a cycle has been interrupted, cannot be deactivated. To indicate the status of the cycle. The display will indicate cycle progress such as Washing, Drying, Clean, and Sanitized. The cycle has completed when the Clean light is lit. If you select the Sani Rinse option, when the cycle is finished, the Sanitized indicator glows. If the dishwasher did not properly sanitize your dishes, the Sanitized indicator flashes at the end of the cycle. This can happen if the cycle is interrupted or if water could not be heated to required temperature. The light goes off when you open and close door or touch Cancel. Canceling a Cycle 1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door. 2. Press and hold Cancel/DRAIN once. The Cancel/DRAIN light will light up. 3. Close the door and the dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the dishwasher drain completely. The Cancel/DRAIN light turns off after2 minutes. Changing a Cycle After Dishwasher Is Started You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure: 1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely. 2. Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before restarting your new cycle. 3. Press Cancel/DRAIN and wait approximately 2 minutes until the machine drains and the Cancel/DRAIN light turns off. 4. Select new cycles and options. 5. Press Start/RESUME. Adding a Dish After Dishwasher Is Started 1. Open the door slightly to stop the cycle. Wait for the spraying action to stop and then completely open the door. 2. If the detergent dispenser door is closed you may add a dish. If the detergent dispenser door is already opened an added dish might not be cleaned. 3. Press Start/RESUME and close the door. If the door is not closed within 4 seconds, you will hear a series of beeps and the dishwasher will not start. 10