KitchenAid KDFE304DWH Use & Care Guide - Page 10

OPTION SELECTIONS OPTIONS CAN BE SELECTED WITH WHAT IT DOES ADDED TIME TO CYCLE TYPICAL MAX ADDED WATER GALLONS (LITERS) Dries dishes with heat and Available with any Uses the heating 44 51 0 a fan. This option with the cycle except Rinse element to heat air, use of rinse aid will provide Only plus a system of the best drying vents and a fan that performance. Plastic items ventilates moist air are less likely to deform out of the when loaded in the top dishwasher to rack. Turn ProDry™ option speed drying times. off for an air dry. ProDry™ option defaults to ON when any cycle is selected except for 1 Hour Wash. Dries dishes with heat. Available with any Activates the 52 52 0 This option with the use of cycle except Rinse heating element at rinse aid will provide the Only the end of the wash best drying performance. cycle to speed Plastic items are less likely drying times. Heat to deform when loaded in Dry defaults to ON the top rack. Turn Heat Dry when any cycle is off for an air dry. selected except for 1 Hour Wash. Runs the dishwasher at a Available with any Delays the start of a 240 480 0 later time or during off- cycle cycle to the peak electrical hours. specified time. Select a wash cycle and or options. Press the Delay button. Press START/ RESUME. Close the door firmly. NOTE: Anytime the door is opened (such as, to add a dish), the Start/Resume button must be pressed again to resume the delay countdown. Avoids unintended use of the dishwasher between cycles, or cycle and option changes during a cycle. To turn on Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The Control Lock light will stay on for a short time, indicating that it is activated, and all buttons are disabled. If you press any button while your dishwasher is locked, the light flashes 3 times. The dishwasher door can still be opened/closed while the controls are locked. or NOTE: You may need to disable Sleep Mode by pressing either START/RESUME or CANCEL, or by opening and closing the door before you are able to turn Control Lock off. To turn off Control Lock, press and hold CONTROL LOCK or 4 HOUR DELAY (depending on model) for 3 seconds. The light turns off. NOTE: If your model requires you to press and hold 4 HOUR DELAY to lock the controls, the Control Lock LED will be on or off to indicate if Control Lock is active or not. CONTROLS AND CYCLE STATUS CONTROL PURPOSE To start or resume a wash cycle COMMENTS If the door is opened during a cycle or the power is interrupted, the Start/Resume indicator flashes. The cycle will not resume until the door is closed and START/RESUME is pressed. NOTE: If the Start/Resume button is located on top of door, push door firmly closed within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds, the Start/Resume button LED will flash, an audible tone will be heard, and the cycle will not start. 10