KitchenAid KICU569XSS Installation Guide - Page 6

4. Make sure that the clips on each side of the cooktop line up with the brackets in the cutout. A Make Electrical Connection WARNING A. Clip 5. Push down on cooktop to snap the cooktop clips onto the brackets installed in the cutout. A Electrical Shock Hazard Disconnect power before servicing. Use 8 gauge copper wire. Electrically ground cooktop. Failure to follow these instructions can result in death, fire, or electrical shock. This cooktop is manufactured with a frame-connected, green (or bare) ground wire. 1. Disconnect power. 2. Remove junction box cover if it is present. 3. Connect the flexible cable conduit from the cooktop to the junction box using a UL listed or CSA approved conduit connector. B A. Induction cooktop B. Cooktop cutout 6. On the underside of the cooktop, loosen the 4 screws on the slider. A BC A. Side of cabinet B. Cooktop slider C. Screw 7. Push the cooktop slider toward the side of the cabinet until the slider and cabinet touch. 8. Tighten the screws on the slider. A A. UL listed or CSA approved conduit connector 4. Tighten screws on conduit connector if present. 5. See "Electrical Connection Options Chart" to complete installation for your type of electrical connection. Electrical Connection Options Chart If your home has: Go to Section: 4-wire 4-Wire Cable from Home Power Supply 3-wire ½" (1.3 cm) 3-Wire Cable from Home Power Supply ½" (1.3 cm) 6