KitchenAid KMBD104GSS Installation Instructions - Page 3
Installation Requirements, Tools and Parts, Minimum Dimensions - installation manual
View all KitchenAid KMBD104GSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
INSTALLATION REQUIREMENTS These installation instructions cover different models. The appearance of your particular model may differ slightly from the illustrations in these Installation Instructions. Minimum Dimensions Tools and Parts Minimum Wall Oven Combination Installation Clearances Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here. Tools needed ■■ Tape measure ■■ #2 Phillips screwdriver ■■ 1/8" (3.17 mm) drill bit ■■ Marker or pencil For proper installation, the following minimum clearances must exist above and below the cutout opening. NOTE : Upper oven must have heat deflector kit installed to direct exhaust away from microwave console (Refer to Wall Oven Manual for Deflector Kit Installation) A ■■ Drill Parts supplied The Microwave Drawer is preassembled. ■■ 1" (2.5 cm) mounting screws (4) 2" (5.1 cm) Verification needed ■■ Installer must confirm presence of anti tip block. Refer to the anti-tip block section in the manual. B ■■ Check local codes. Check existing electrical supply. See "Electrical Requirements". ■■ It is required that all electrical connections be made by a licensed, qualified electrical installer. Location Requirements This product is suitable for use below electric or gas built-in ovens. This product is not suitable for use below cooktops. The Microwave Drawer may be located in a cabinet or below the counter, and/or below a built-in oven. Check the opening where the Microwave Drawer will be installed. The location must provide: IMPORTANT: Observe all governing codes and ordinances. ■■ Wood cabinetry. ■■ Cutout opening that is plumb and square. See "Minimum Cutout Dimensions" in the "Minimum Dimensions" section. ■■ Cutout floor that is solid, level, and flush with bottom of cabinet cutout. ■■ Support for weight of at least 100 lbs (45.4 kg), which includes Microwave Drawer and items placed inside. ■■ Grounded electrical outlet. See the "Electrical Requirements" section. ■■ Minimum installation clearances for installation location. See the "Minimum Dimensions" section. ■■ Complete enclosure around the recessed portion of the Microwave Drawer. A. Upper oven cutout B. Microwave drawer cutout 3