KitchenAid KRFF507HPS Owners Manual - Page 28
Dec-2020 11:40:23 EST | RELEASED, Application Guidelines/Water Supply Parameters
View all KitchenAid KRFF507HPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
� For installation, operation, and maintenance instructions please � Do not use with water that is microbiologically unsafe or of refer to the Owner's Manual. unknown quality without adequate disinfection before or after � It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. Property damage can occur if all the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts. EPA Est. No. 082047-TWN-001. instructions are not followed. � Refer to the "Warranty" for the Manufacturer's limited warranty, � The disposable cartridge must be changed at least every 6 name and telephone number. months. � Use replacement filter P9RFWB2L, part #EDR2RXD1/ Application Guidelines/Water Supply Parameters EDR2RXD1B. 2015 suggested retail price of $49.99 U.S.A./ $49.99 Canada. Prices are subject to change without notice � The filter monitor system measures the amount of water that passes through the filter and alerts you when it is time to replace Water Supply Water Pressure Water Temperature Potable City or Well 30 - 120 psi (207 - 827 kPa) 33° - 100°F (0.6° - 37.8°C) the filter. Service Flow Rate 0.6 GPM (2.27 L/min.) @ 60 Refer to the "Using the Controls" or "Water Filtration System" psi. (413.7 kPa) section to learn how to check the water filter status. � After changing the water filter, flush the water system. See "Water and Ice Dispensers" or "Water Dispenser". � These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory � Your water filtration system will withstand up to 120 pounds per square inch (psi) water pressure. If your water supply is higher than 80 psi, install a pressure reducing valve before installing the water filtration system. conditions, actual performance may vary. � The product is for cold water use only. � The water system must be installed in compliance with state and local laws and regulations. *Class I particle size: >0.5 to 1 um †Based on the use of Cryptosporidium parvum oocysts ††Fibers greater than 10 um in length ®NSF is a registered trademark of NSF International. 28 17-Dec-2020 11:40:23 EST | RELEASED In some European factories the letter "W" of the part code mentioned herein will be automatically replaced by the number "4000" (e.g. "W12345678" becomes "400012345678")