KitchenAid KUDD03DTPA Use & Care Guide - Page 8

Dishwasher Care, Troubleshooting

Page 8 highlights

RINSE AID DISPENSER LEVEL 0 OFF OFF OFF 1 ON OFF OFF 2 ON ON OFF 3 ON ON ON NOTE: A rinse aid dispenser level of "0" disables the Rinse-Aid Low indicator light. To exit the Rinse Aid Adjustment Mode: Press any key other than High Temp Scrub to exit the Rinse Aid Adjustment Mode. Tone Option Adjustment Mode 1. Press and hold the High Temp Scrub option pad for 3 seconds. A tone will sound to indicate you have entered the Tone Option Adjustment Mode. 2. To change the tone options, press the 4-Hour Delay option pad. 3. Each press of the 4-Hour Delay pad will move through each available setting. Continue to press the 4-Hour Delay until reaching the desired tone option. See table. TONE OPTIONS STATUS INDICATOR LIGHTS Sanitized Rinse Aid Low Drawer open/button press/ OFF OFF End-of-cycle chime disabled Dishwasher Care Cleaning the Dishwasher Clean the exterior of the dishwasher with a soft, damp cloth and mild detergent. If your dishwasher has a stainless steel exterior, a stainless steel cleaner is recommended. NOTE: Do not clean the dishwasher interior until it has cooled. Clean the interior of the dishwasher, with a paste of powdered dishwasher detergent and water or use liquid dishwasher detergent on a damp sponge to clean the cooled-down interior. Cleaning the Coarse Filter Cup 1. Pull drawer out to its full extension. Remove rack inserts from rack and set aside. 2. To remove the coarse filter cup, unscrew the small cap, turning in a counterclockwise motion. Lift and remove the coarse filter cup out of the drawer. 3. Empty the cup of hard objects and food soil. Rinse cup under hot water. A white vinegar rinse may remove white spots and film. Vinegar is an acid, and using it too often could damage your dishwasher. Put 2 cups (500 mL) white vinegar in a glass or dishwasher-safe measuring cup on the bottom rack. Run the dishwasher through a complete washing cycle using an air-dry or an energy-saving dry option. Do not use detergent. Vinegar will mix with the wash water. 4. Place the coarse filter cup back into the coarse filter plate and tighten the cap, turning in a clockwise motion. Make sure the coarse filter cup is flush with the coarse filter plate. 5. Replace the rack inserts. 6. Make sure spray arm rotates freely. Periodically clean the coarse filter cup located on the floor of the dishwasher drawer. Remove collected particles from the coarse filter cup. IMPORTANT: Do not start the dishwasher until the coarse filter cup is securely in place and flush with the coarse filter plate. Doing so may damage the dishwasher motor and/or spray arm. If you have a drain air gap, check and clean it if the dishwasher isn't draining well. Storing the Dishwasher If you will not be using the dishwasher during the summer months, turn off the water and power supply to the dishwasher. In the winter, if the dishwasher could be exposed to near freezing temperatures or is left in a seasonal dwelling such as a second home or vacation home, avoid water damage by having your dishwasher winterized by authorized service personnel. Troubleshooting First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call. In the U.S.A., www.kitchenaid.com In Canada, www.kitchenaid.ca Dishwasher is not operating properly ■ Dishwasher does not run or stops during a cycle Is the drawer closed tightly? Was the drawer closed within 4 seconds after pressing Start/ Resume? Is the right cycle selected? Was the drawer opened in mid-cycle. Are indicator lights flashing? Start/Resume will need to be pressed and the drawer closed within 4 seconds before the cycle will resume. Is there power to the dishwasher? Has a household fuse blown, or has a circuit breaker tripped? Replace the fuse or reset the circuit breaker. If the problem continues, call an electrician. Is the water shutoff valve (if installed) turned on? ■ Dishwasher seems to run too long The dishwasher can run up to 3 hours depending on soil level, water temperature, cycles and options. Is the water supplied to the dishwasher hot enough? The dishwasher runs longer while heating water. ■ Dishwasher did not drain/Water in bottom of tub Is the cycle complete? Is there food or foreign objects in the drain filter, coarse filter cup, or disposer? Clean if needed. Is the dishwasher hooked up to a food waster disposer? Is the knockout removed? Is the drain hose bent or kinked? Straighten or unblock hose. 8

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23

8
NOTE:
A rinse aid dispenser level of “0” disables the Rinse-Aid
Low indicator light.
To exit the Rinse Aid Adjustment Mode:
Press any key other than High Temp Scrub to exit the Rinse Aid
Adjustment Mode.
Tone Option Adjustment Mode
1.
Press and hold the High Temp Scrub option pad for
3 seconds. A tone will sound to indicate you have entered the
Tone Option Adjustment Mode.
2.
To change the tone options, press the 4-Hour Delay option
pad.
3.
Each press of the 4-Hour Delay pad will move through each
available setting. Continue to press the 4-Hour Delay until
reaching the desired tone option. See table.
Dishwasher Care
Cleaning the Dishwasher
Clean the exterior of the dishwasher with a soft, damp cloth and
mild detergent. If your dishwasher has a stainless steel exterior, a
stainless steel cleaner is recommended.
NOTE:
Do not clean the dishwasher interior until it has cooled.
Clean the interior of the dishwasher, with a paste of powdered
dishwasher detergent and water or use liquid dishwasher detergent
on a damp sponge to clean the cooled-down interior.
A white vinegar rinse may remove white spots and film. Vinegar is
an acid, and using it too often could damage your dishwasher.
Put 2 cups (500 mL) white vinegar in a glass or dishwasher-safe
measuring cup on the bottom rack. Run the dishwasher through a
complete washing cycle using an air-dry or an energy-saving dry
option. Do not use detergent. Vinegar will mix with the wash water.
Cleaning the Coarse Filter Cup
1.
Pull drawer out to its full extension. Remove rack inserts from
rack and set aside.
2.
To remove the coarse filter cup, unscrew the small cap, turning
in a counterclockwise motion. Lift and remove the coarse filter
cup out of the drawer.
3.
Empty the cup of hard objects and food soil. Rinse cup under
hot water.
4.
Place the coarse filter cup back into the coarse filter plate and
tighten the cap, turning in a clockwise motion. Make sure the
coarse filter cup is flush with the coarse filter plate.
5.
Replace the rack inserts.
6.
Make sure spray arm rotates freely.
Storing the Dishwasher
If you will not be using the dishwasher during the summer months,
turn off the water and power supply to the dishwasher. In the
winter, if the dishwasher could be exposed to near freezing
temperatures or is left in a seasonal dwelling such as a second
home or vacation home, avoid water damage by having your
dishwasher winterized by authorized service personnel.
Troubleshooting
First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)
to possibly avoid the cost of a service call.
In the U.S.A., www.kitchenaid.com
In Canada, www.kitchenaid.ca
Dishwasher is not operating properly
Dishwasher does not run or stops during a cycle
Is the drawer closed tightly?
Was the drawer closed within 4 seconds after pressing Start/
Resume?
Is the right cycle selected?
Was the drawer opened in mid-cycle. Are indicator lights
flashing? Start/Resume will need to be pressed and the drawer
closed within 4 seconds before the cycle will resume.
Is there power to the dishwasher? Has a household fuse blown,
or has a circuit breaker tripped? Replace the fuse or reset the
circuit breaker. If the problem continues, call an electrician.
Is the water shutoff valve (if installed) turned on?
Dishwasher seems to run too long
The dishwasher can run up to 3 hours depending on soil level,
water temperature, cycles and options.
Is the water supplied to the dishwasher hot enough? The
dishwasher runs longer while heating water.
Dishwasher did not drain/Water in bottom of tub
Is the cycle complete?
Is there food or foreign objects in the drain filter, coarse filter
cup, or disposer? Clean if needed.
Is the dishwasher hooked up to a food waster disposer? Is the
knockout removed?
Is the drain hose bent or kinked? Straighten or unblock hose.
RINSE AID
DISPENSER
LEVEL
0
OFF
OFF
OFF
1
ON
OFF
OFF
2
ON
ON
OFF
3
ON
ON
ON
TONE OPTIONS STATUS
INDICATOR LIGHTS
Sanitized
Rinse Aid Low
Drawer open/button press/
End-of-cycle chime disabled
OFF
OFF
Periodically clean the coarse
filter cup located on the floor of
the dishwasher drawer. Remove
collected particles from the
coarse filter cup.
IMPORTANT:
Do not start the
dishwasher until the coarse filter
cup is securely in place and
flush with the coarse filter plate.
Doing so may damage the
dishwasher motor and/or spray
arm.
If you have a drain air gap,
check and clean it if the
dishwasher isn't draining
well.