KitchenAid KUDS03FTPA Installation Instructions - Page 9

Option 2: No waste disposer - with air gap: 1. Cut end of drain hose if needed (do not cut ribbed section). 2. Attach drain hose to air gap with large spring-type clamp. If the drain hose was cut, use a 1-1/2" to 2" (3.8 to 5 cm) screw-type clamp*. 3. Use a rubber hose connector* with spring or screw-type clamps* to connect air gap to waste tee. This connection must be before the drain trap and at least 20" (50.8 cm) above the floor where dishwasher will be installed. drain hose - cut here if needed rubber hose connector air gap spring or screw-type clamps large spring-type clamp drain trap waste tee drain hose 4. Insert drain hose through hole cut in cabinet to the front center of opening where drain connection will be made. drain hose * Parts available from local plumbing supply stores Option 3: Waste disposer - no air gap: 1. Remove the disposer knockout plug. Do not cut end of drain hose. 2. Attach drain hose to disposer inlet with large spring-type clamp. This connection must be before the drain trap and at least 20" (50.8 cm) above the floor where dishwasher will be installed. It is recommended that the drain hose be looped up and securely fastened to the underside of the counter. large spring-type clamp disposer inlet drain hose Option 4: No waste disposer - no air gap: 1. Cut end of drain hose if needed (do not cut ribbed section). 2. Attach drain hose to waste tee with 1-1/2" to 2" (3.8 to 5 cm) screw-type clamp*. This connection must be before the drain trap and at least 20" (50.8 cm) above the floor where dishwasher will be installed. It is recommended that the drain hose be looped up and securely fastened to the underside of the counter. drain hose - cut here if needed screw-type clamp waste tee drain trap 3. Insert drain hose through hole cut in cabinet to the front center of opening where drain connection will be made. * Parts available from local plumbing supply stores drain hose drain hose Install moisture barrier (on some models) 1. Make sure the area under the cabinet is clean and dry for installation of the moisture barrier. 2. Remove the backing of the moisture barrier and apply to underside of the countertop along the front edge of the counter. moisture barrier drain trap 3. Insert drain hose through hole cut in cabinet to the front center of opening where drain connection will be made. drain hose 9