Kodak I6015 User Guide - Page 8

Installing the scanner - check scanner drivers

Get Kodak I6015 - Check Scanner PDF manuals and user guides View all Kodak I6015 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

Installing the scanner Follow the instructions below to install your Kodak i6000 Series Check Scanners. NOTES: • Make sure that the power outlet is located within 1.52 metres (5 feet) of the scanner and is easily accessible. • Use only the power supply that was provided with the Kodak i6000 Series Check Scanners. Do not substitute another power supply model or another manufacturer's power supply. • Place the power supply on the floor. Do not place it next to the scanner. Failure to do so may result in degraded MICR read rates. 1. Place the scanner on a flat surface near the PC that you are connecting it to. Do not install it in a location where it will be in direct sunlight. 2. Plug the output power cord from the power supply into the power port on the scanner. Be sure this is done before plugging the power cord into the wall outlet. 3. Plug the other end of the power cord into the wall outlet. 4. Connect the USB cable between your scanner and PC. IMPORTANT: DO NOT turn on the scanner until the drivers are installed on the PC and the PC is powered on. The drivers will not load properly if Windows detects the USB device prior to having the drivers installed. 6 A-61557 December 2006

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
6
A-61557 December 2006
Installing the scanner
Follow the instructions below to install your
Kodak
i6000 Series Check
Scanners.
NOTES:
•
Make sure that the power outlet is located within 1.52 metres
(5 feet) of the scanner and is easily accessible.
•
Use only the power supply that was provided with the
Kodak
i6000
Series Check Scanners. Do not substitute another power supply
model or another manufacturer’s power supply.
•
Place the power supply on the floor. Do not place it next to the
scanner. Failure to do so may result in degraded MICR read rates.
1.
Place the scanner on a flat surface near the PC that you are
connecting it to. Do not install it in a location where it will be in direct
sunlight.
2.
Plug the output power cord from the power supply into the power
port on the scanner.
Be sure this is done before plugging the
power cord into the wall outlet.
3.
Plug the other end of the power cord into the wall outlet.
4.
Connect the USB cable between your scanner and PC.
IMPORTANT:DO NOT turn on the scanner until the drivers are
installed on the PC and the PC is powered on. The
drivers will not load properly if Windows detects the
USB device prior to having the drivers installed.