Konica Minolta AccurioPress C6100 AccurioPress C6100/C6085 User Guide Addition - Page 11
General Inquiries
View all Konica Minolta AccurioPress C6100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3 General Inquiries 3.1 3 Troubleshooting 3.1 General Inquiries User's guide / Addition position
3-2
AccurioPress C6100/C6085
General Inquiries
3
3.1
3
Troubleshooting
3.1
General Inquiries
<Additional information>
When Intelligent Quality Optimizer IQ-501 is mounted, [Both Sides Adj.] was
performed in [Auto Image Adjustment], but a misalignment occurred be-
tween the front and back positions of the original.
User's guide / Addition posi-
tion
Description
<HTML User's Guide>
[Troubleshooting]
)
[General In-
quiries]
Addition of items
For details, refer to the following.
Cause
The unit is converted from mm or inch to pt in RIP processing of the
EFI controller. At this time, a rounding error may occur because the
number is indivisible.
If a rounding error occurs, the image position is misaligned by 1 pt
(approximately 0.35 mm / 0.013").
If this problem occurs, the original image position is also misaligned,
so this misalignment cannot be adjusted using the [Auto Image Ad-
justment] function of
Intelligent Quality Optimizer IQ-501
.
Option
Intelligent Quality Optimizer IQ-501
, EFI controllers
Working time
10 minutes
Overview
This problem can be resolved by setting [Image Shift] in the printer
driver or Command WorkStation (CWS).
Precautions
A misalignment between the front and back positions occur for sev-
eral reasons.
Check whether the paper used for both sides adjustment is cut cor-
rectly.
Procedure
The following procedure shows an example for the Fiery color serv-
er.
1. When
Intelligent Quality Optimizer IQ-501
is mounted, select
[MACHINE] - [Paper Setting] - [Both Sides Adj.] - [AutoMeasure] on
the
touch panel
.
2. Correct the misalignment between image positions for each paper
tray. [AutoMeasure] allows you to collectively adjust multiple paper
trays, or output multiple charts to enhance the adjustment accuracy.
3. Open [Properties] of the job in the printer driver or Command
WorkStation (CWS).
4. Set the shift amount in [Imae Shigft]. It is recommended that you
shift the front side by 1 pt (approximately 0.35 mm / 0.013") in the
paper feed direction.