Kyocera FS-1124MFP 120v User Guide 2 - Page 256
Responding to an Error Lamp Flashes, Symptom, Checkpoints, Corrective Actions, Reference
View all Kyocera FS-1124MFP 120v manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 256 highlights
Troubleshooting Responding to an Error Lamp Flashes If an error lamp flashes, press [Status/Job Cancel] to check an error message. If the message is not indicated on the Message Display when [Status/Job Cancel] is pressed or the error lamp flashes for 1.5 seconds, check the following. Symptom Cannot send fax. Checkpoints Is the modular cord connected correctly? Is Permitted FAX No. or Permitted ID No. registered correctly? Has a communication error occurred? Is the destination FAX line busy? Does the destination FAX machine respond? Is there an error other than above? Corrective Actions Reference Page Connect the modular - cord correctly. Check Permitted FAX No. and Permitted ID No.. FAX Operation Guide Chapter 6 "Registering Permit FAX No." and "Registering Permit ID No." Check error codes in the TX/RX Result Report and Activity Report. If the error code starts with "U" or "E", perform the corresponding procedure. FAX Operation Guide Appendix "Error Code List" Send again. - Send again. - Contact your Service - Representative. 10-8 OPERATION GUIDE