Kyocera FS 4000DN FS-2000D/3900DN/4000DN Operation Guide Rev-1.2 (Advanced Edi - Page 58
>Baud Rate, >Data Bits, >Stop Bits, >Parity, >Protocol, DTRpos.&XON
View all Kyocera FS 4000DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Using the Operation Panel Pressing ? or @ toggles through the serial parameters as follows. To change the serial parameter, press [OK]. Use ? or @ to change the value or selection. >Baud Rate 9600 Range 1200, 2400, 4800, 9600 (Default), 19200, 38400, 57600, 115200 >Data Bits 8 7 or 8 (Default) >Stop Bits 1 1 (Default) or 2 >Parity None None (Default), Odd, Even, or Ignore >Protocol DTR(pos.)&XON DTR(pos.)& Xon (Default), DTR(positive), DTR(negative), XON/XOFF, or ETX/ACK For example, to change baud rate from 9600 to 115200, display the baud rate menu following the above procedure. When the display shows baud rate, 9600 (bps), press [OK]. A blinking question mark (?) appears. >Baud Rate ? 9600 7 Press ? or @ to scroll through values. When 115200 is displayed, press [OK]. Press [Menu] to exit the menu selection. NOTE: Some computers may not be able to handle a baud rate of 115200 bps. If you set the baud rate to 115200 and encounter communication problems, select a lower baud rate. 2-32 ADVANCED OPERATION GUIDE