Kyocera FS 4000DN FS-2000D/3900DN/4000DN Operation Guide Rev-1.2 (Advanced Edi - Page 61
Using the Operation Panel, ADVANCED OPERATION GUIDE
View all Kyocera FS 4000DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Using the Operation Panel 2 Enter the submenu by pressing B. Each time you press ? or @, the selection changes. >>DHCP Off >>BOOTP Off >>IP Address 000.000.000.000 >>Subnet Mask 000.000.000.000 >>Gateway 000.000.000.000 3 When >>IP Address is displayed, press [OK]. A blinking cursor (_) appears at the last digit. >>IP Address 000.000.000.000 4 Press ? or @ to increase or decrease, respectively, the value at the blinking cursor. Use B and A to move the cursor right and left. 5 When the IP address is entered, press [OK]. 6 Press ? or @ to move to Subnet Mask. Perform the same procedure to complete entering the subnet mask address. 7 Then, press ? or @ to move to Gateway. Perform the same procedure to complete entering the gateway address. 8 Press [Menu]. The display returns to Ready. You can print a network status page to confirm that the IP address, subnet mask address, and the gateway address have been properly set. To print a network status page, refer to Printing a Network Interface Status Page on page 2-36. ADVANCED OPERATION GUIDE 2-35