Kyocera FS-4020DN FS-2020D/3920DN/4020DN Operation Guide (Advanced) - Page 57
Font Select (Selecting the default font), >Emulation, PCL 6, KPDL AUTO, >>Error Report
View all Kyocera FS-4020DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
>Emulation ? PCL 6 >Emulation > ? KPDL (AUTO) >>Error Report ? On >Font Select > Internal >> I000 >>?I000 Error Report (Printing KPDL errors) The printer can print error descriptions when printing error occurs during KPDL emulation. The default is On - the printer prints KPDL errors. 1 Press Z while Print Settings > is displayed. 2 Press U or V repeatedly until >Emulation > appears. 3 Press [OK]. A blinking question mark (?) appears. 4 Select KPDL or KPDL (AUTO) using U or V. Press [OK]. 5 Press Z. >>Error Report appears. 6 Press [OK]. A blinking question mark (?) appears. 7 Select On or Off using U or V. Press [OK]. 8 Press [MENU]. The display returns to Ready. Font Select (Selecting the default font) You can select the default font for the current interface. The default font can be one of the internal fonts or a font that is downloaded to the printer memory or stored on CompactFlash card, or hard disk. In this menu, you can also set the type and pitch for Courier and Letter Gothic; as well as to print a font list. 1 Press Z while Print Settings > is displayed. 2 Press U or V repeatedly until >Font Select > appears. 3 To select an internal font, make sure that Internal is displayed and press Z. The display changes. If Internal is not displayed, press [OK], then press U or V until it appears. To select an optional font, press [OK] while >Font Select > is displayed. Press U or V repeatedly until Option appears and then press [OK]. Press Z next to display the font selection shown above. You can perform this operation only when optional fonts are installed in the printer. The letter before the number indicates the location of the font, as shown below. I: Internal font S: Soft (downloaded) font M: Fonts in optional CompactFlash card H: Fonts in RAM disk or optional hard disk 4 Press [OK]. A blinking question mark (?) appears. Using the Operation Panel 2-39