Kyocera FS 9520DN FS-9120DN/9520DN Operation Guide Rev-2 - Page 108
Port Settings, B-4
View all Kyocera FS 9520DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 108 highlights
5 The Properties sheet is displayed for the selected COM port. Click on the Port Settings tab and set the port properties. Appendix B Host Computer Interface Figure B-4 6 After setting the properties, click the OK button. I DOS 1 Enter the following commands: C:\>MODE COM1:96,N,8,1,P C:\>MODE LPT1:=COM1 2 To test the interface, enter the following: CTRL P C:\>DIR CTRL P The software settings made using the above procedures are temporary. On most computers, permanent settings must be made with DIP switches. B-6
Appendix B
Host Computer Interface
B-6
The Properties sheet is displayed for the selected
COM
port. Click on the
Port Settings
tab and set the
port properties.
Figure B-4
After setting the properties, click the
OK
button.
â–
DOS
Enter the following commands:
C:\>MODE COM1:96,N,8,1,P
C:\>MODE LPT1:=COM1
To test the interface, enter the following:
CTRL P
C:\>DIR
CTRL P
The software settings made using the above procedures are
temporary. On most computers, permanent settings must be
made with DIP switches.
5
6
1
2