Kyocera KM-4035 Scan System Operation Guide (Functions Edition) Rev-9 - Page 136
DNS Server Pri.
View all Kyocera KM-4035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Address Editor 1. Network 1/ Network 2 / IP-Filters Tabs Click on the desired tab to switch between network 1, network 2 and IP Filters settings. In [Network 1] tab 2. Host Name Type the host name of the scanner (up to 32 single-byte characters) in this field. 3. IP Address Type the IP address of the Scanner Interface Card in this field in the following form: XXX.XXX.XXX.XXX Whenever you attempt to change the IP address, a confirmation dialogue box will appear in which you will need to verify that you really want to change the address. 4. Subnet Mask Type the subnet mask of the Scanner Interface Card in this field in the following form: XXX.XXX.XXX.XXX 5. Default Gateway Type the default gateway of the Scanner Interface Card in this field in the following form: XXX.XXX.XXX.XXX * This is used for transmitting packets to another network or subnet. 6. DHCP/BOOTP The DHCP and BOOTP can be set to either "ON" or "OFF". The factory default setting is "ON". 7. RARP The RARP can be set to either "ON" or "OFF". The factory default setting is "ON". 8. ARP/PING The ARP/PING can be set to either "ON" or "OFF". The factory default setting is "ON". 9. DNS Server (Pri When a host name is used for transmitting data under an environment that uses a DNS server, type the IP address of the primary DNS server in this field in the following form: XXX.XXX.XXX.XXX 10. DNS Server (Sec Type the IP address of the secondary DNS server in this field in the following form: XXX.XXX.XXX.XXX 11. DNS Domain Name ....... Type the domain name (up to 32 single-byte characters) in this field. Page 3-40