Kyocera KM-C3225E DF-710/MT-710/BF-710/PH-5A Operation Guide Rev-1 - Page 16
Interrupt Mode, English, DF-710, MT-710, PH-5A, PH-5B AND PH-5C OPERATION GUIDE, Hole Punch mode - copier
View all Kyocera KM-C3225E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
English 2 Load the originals in the Document Processor, or one at a time on the Platen. Ensure the orientation of the originals is the same as that selected for Hole Punch mode on the machine. NOTE: Refer to the Operation Guide for the machine for Document Processor and Platen specifications. 3 Select other features as required and press Start. 4 The copies are automatically hole punched and ejected onto the selected tray. NOTE: Holes are punched in each copy individually, therefore the location of the holes may vary on each sheet. On completion of the job, remove all the copies. Interrupt Mode 1 Specify the settings for interrupt mode at from the machine operation panel. NOTE: For more information on interrupt mode operation, see the machine operation guide. Specify the output tray at the machine. 2 Take out the any existing original and set the original to use for interrupt mode. 3 Set desired copier functions or output tray destination and press Start. Copying begins and paper is output to the selected tray. When done copying in interrupt mode, turn off interrupt copy mode from the machine itself. 4 Replace the original and press Start. Copying of the interrupted job resumes. 14 DF-710, MT-710, BF-710, PH-5A, PH-5B AND PH-5C OPERATION GUIDE