Kyocera TASKalfa 250ci 250ci/300ci/400ci/500ci/552ci Operation Guide Rev-1 - Page 73
Original placement indicator, How to Load Originals, IMPORTANT
View all Kyocera TASKalfa 250ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Preparation before Use How to Load Originals IMPORTANT: Before loading originals, be sure that there are no originals left on the original eject table. Originals left on the original eject table may cause the new originals to jam. 2 1 Adjust the original width guides to fit the originals. Original placement indicator 2 Place the originals. Put the side to be scanned (or the first side of two-sided originals) face-up. Slide the leading edge into the document processor as far as it will go. The original placement indicator will be lit. IMPORTANT: Confirm that the original width guides exactly fit the originals. If there is a gap, readjust the original width guides. The gap may cause the originals to jam. Ensure that loaded originals do not exceed the level indicator. Exceeding the maximum level may cause the originals to jam (see the figure). Originals with punched holes or perforated lines should be placed in such a way that the holes or perforations will be scanned last (not first). The original placement indicator is lit or unlit depending on how originals are placed. Indications and their status are as follows. • Green (left indicator) lit: Original is placed properly. • Green (left indicator) blinking: Original is not placed properly. Remove and place again. • Red (right indicator) blinking: Original is jammed. Remove the jammed original and place it properly. 2-35