Kyocera TASKalfa 3050ci Kyocera Command Center RX User Guide Rev-1.2 - Page 54
Advanced > Protocols > TCP/IP > Logical Printers, IP Filters IPv6, IP Address IPv6, Prefix Length
View all Kyocera TASKalfa 3050ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Settings Pages 6-32 • HTTP • Raw • SNMP • IPP over SSL • HTTPS IP Filters (IPv6) • IP Address (IPv6) Specifies the IP addresses to which access is granted. When there are no entries, access is allowed to all. The number of addresses that can be specified depends on the IPv6 network address along with the prefix length setting. To filter a single IPv6 address: Enter the desired IPv6 address, along with a prefix length of 128. • Prefix Length Specifies the IPv6 prefix length. It can be a decimal value between 0 and 128. • Protocols Specifies the protocols through which access is granted. The following protocols can be selected. • LPD • FTP • IPP • ThinPrint • HTTP • Raw • SNMP • IPP over SSL • HTTPS Advanced > Protocols > TCP/IP > Logical Printers This page allows you to configure the Logical Printers. This machine can be used as a virtual printer for converting ASCII print data to PostScript data or for adding and/or replacing a character strings (commands) at the beginning or end of job data. Up to four logical printers can be set. Each logical printer can be used with either following print protocols: FTP, LPR, IPP, IPPS, SMB (NetBEUI), or RAW. If no port is specified during print, the default port used will be Logical Printer 1 (LP1), port 9100. TCP/IP Port Number Specifies the port number for the logical printer as well as the TCP raw port number (9100, etc.). Conversion is applied to data that is input to the specified raw port in accordance with the selected logical printer. This port is invalid if it is given a port number that is the same as that of an already specified port (For example, FTP or LPD). Bi-directional Printing Bi-directional Printing can be set to On or Off when printing to the the TCP/IP RAW port. When Bi-directional Printing = Off, all send data is discarded. In order to have the data that is received from the printer returned to the client when printing with PostScript, PJL and other such commands, it is necessary to set Bi-directional Printing = On. User Guide