Kyocera TASKalfa 5052ci PRESCRIBE Commands Technical Reference Manual - Rev. 4 - Page 216
OA [Output Actual position and pen status], OE [Output Error], OF [Output Factors]
View all Kyocera TASKalfa 5052ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 216 highlights
Chapter 7 Emulation OA [Output Actual position and pen status] The plotter returns the x- and y-coordinates of the current pen position and indicates whether the pen is currently up or down. This information is given by ASCII-coded integers in the following format: X, Y, P TERM X: x-coordinate in absolute plotter units Y: y-coordinate in absolute plotter units P: 0 if the pen is up; 1 if the pen is down OC [Output Commanded position and pen status] The plotter returns the x- and y-coordinates and pen status for the last valid pen positioning instruction. The pen position and status are ASCII-coded in the same way as the OA instruction. Coordinate values are given in plotter units if scaling is off, or user units if scaling is on. OE [Output Error] The plotter returns a decimal error number for the instruction executed immediately before the OE instruction. The error code is converted to a non-negative ASCII-coded integer whose identity is given in the following table. Error Number Description 0 No error 1 Instruction not recognized 2 Wrong number of parameters 3 Illegal parameter 4 (Reserved) 5 Unknown character set 6 Plot position overflow 7 (Reserved) OF [Output Factors] This instruction returns the number of plotter units per millimeter on each coordinate axis, as follows: 40, 40 TERM This response indicates that plotter units are equal to 0.025 mm on both the x- and yaxes. The actual number of plotter units per millimeter is approximately 40. OH [Output Hard-clip limits] This instruction returns the lower left and upper right limiting coordinates of the plot area, in the following format: XLL, YLL, XUR, YUR TERM LL: lower left UR: upper right 7-104