Kyocera TASKalfa 5052ci PRESCRIBE Commands Technical Reference Manual - Rev. 4 - Page 26
Relative Lines, Result of Draw Commands: Zero-relative Lines
View all Kyocera TASKalfa 5052ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Chapter 2 Graphics Tutorial Figure 2. 2. Result of Draw Commands: Zero-relative Lines Edge limits MZP 0.5, 1; DZP 2, 0.5; The first two lines switch the printing system to the PRESCRIBE mode, reset printing system parameters, and set the line width to 0.01 inch. On the third line, the MZP (Move to Zero-relative Position) differs from the MAP (Move to Absolute Position) command in one respect: the position specified is in relation to the top and left edge page limits of the page, rather than in relation to the top and left page margins. MZP moves the cursor to the point that is 0.5 inches from the left edge limit and 1 inch from the top edge limit. Similarly, on the next line, DZP (Draw to Zero-relative Position) draws a line from the starting position to the point 2 inches from the left edge limit and 0.5 inches from the top edge limit. Relative Lines Another way to specify positions is in relation to the current cursor position. The following command sequence provides an example. !R! RES; SPD 0.01; MRP 2, 1; DRP -1.5, -1; MRP 2, 1; DRP -1.5, -1; MRP 2, 1; DRP -1.5, -1; PAGE; EXIT; 2-4