Kyocera TASKalfa 5551ci Kyocera Command Center RX User Guide Rev-2013.02 - Page 86
System stamp, System stamp settings
View all Kyocera TASKalfa 5551ci manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 86 highlights
Management Settings Specifies whether to use authentication traps. If enabled (On), an SNMP trap is generated when an attempt to read or write is made using an incorrect community name. The trap is sent to the configured trap address. After you have changed the setting, you must restart the printing system. Trap Recipient Click Settings button to finalize the settings. 3. Configure SNMPv3 as follows. After you have changed the setting, you must restart the printing system. SNMPv3 Sets whether to use the SNMPv3 protocol. Select either On or Off in the Protocol Settings page under Network Settings. To configure SNMP v3, proceed as follows. Authentication Sets whether the user authentication is performed in SNMP communication. Hash Select either MD5 or SHA1 for Hash algorithm. This item becomes active when the Authentication is set to On. Privacy Sets whether to encrypt the communicated data in SNMP communication. This becomes available when Authentication is set to On. Encryption Select either DES or AES for encryption algorithm. This item becomes active when the Authentication is set to On. Read Only User Enter User Name and Password of the read-only user. Read/Write User Enter User Name and Password of the read/write user. 4. Click Submit button. System stamp This section includes advanced settings that apply to the system stamp. System stamp settings The system stamps include character and serial numbered stamps. Both are applied to printing, sending, and storing jobs. For example, the following describes how to apply the character and serial numbered stamps to a printing job. 82 Embedded Web Server