LG AF115 Owner's Manual - Page 33

Information Replacing the Lamp 1 Turn off the projector and unplug the power cable. Carefully place on a cushioned surface. (Allow the lamp to cool for 1 hour before removing the used lamp from the projector.) 2 Unscrew the screw from the lamp cover using a screwdriver. Lamp cover screw After lifting the lamp cover off, remove the two 3 retaining screws on the lamp case with a screwdriver. 4 Lift the lamp up from the projector. Screws 5 Pull out the handle slowly and remove the lamp case. bottom Knob Insert the new lamp gently into the correct 6 position. Push the lamp bottom to check if it is correctly installed. 7 Tighten the screws you removed in step 3. (Make sure they are fixed firmly.) 8 Close the lamp cover and install the screws from step 2 to install the cover. (If the lamp cover is not installed correctly the unit will not power on.) • Using another manufacturers lamp may cause damage to the projector or lamp. • Make sure the lamp cover is securely fastened. If the lamp cover is not installed correctly the unit will not power on. • If this fault persists contact an LG Authorized Service Center. 33