LG ARUN154DT2 Installation Manual - Page 46
Thermal insulation of refrigerant piping
View all LG ARUN154DT2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Refrigerant piping installation Thermal insulation of refrigerant piping Be sure to give insulation work to refrigerant piping by covering liquid pipe and gas pipe separately with enough thickness heat-resistant polyethylene, so that no gap is observed in the joint between indoor unit and insulating material, and insulating materials themselves. When insulation work is insufficient, there is a possibility of condensation drip, etc. Pay special attention to insulation work to ceiling plenum. B AC Heat insulation Adhesive + Heat - resistant polyethylene foam + material Adhesive tape A Heat insulation material B Pipe C Outer covering (Wind the connection part and cutting part of heat insulation material with a finishing tape.) Outer covering Indoor Vinyl tape Floor exposed Water-proof hemp cloth + Bronze asphalt Outdoor Water-proof hemp cloth + Zinc plate + Oily paint Note: When using polyethylene cover as covering material, asphalt roofing will not be required. Wrong method • Do not insulate gas or low pressure pipe and liquid or high pressure pipe together. B A Liquid pipe A F B Gas pipe C Power lines C D Finishing tape E Insulating material D F Communication lines E • Be sure to fully insulate connecting portion. A A These parts are not insulated. D B C Power lines D A Communication lines Correct method E A Liquid pipe B Gas pipe C Power lines D Insulating material E Communication lines Separation Penetrations Inner wall (concealed) C AB Outer wall Outer wall (exposed) D AB E B Floor (fireproofing) D F G B I Roof pipe shaft G D B Penetrating portion on fire limit and boundary wall I J H A 1m (3.3ft) 1m (3.3ft) Sleeve Heat insulating material Lagging Caulking material Band Waterproofing layer Sleeve with edge Lagging material Mortar or other incombustible caulking Incombustible heat insulation material When filling a gap with mortar, cover the penetration part with steel plate so that the insulation material will not be caved in. For this part, use incombustible materials for both insulation and covering.(Vinyl covering should not be used.) 46 Outdoor Unit