LG BG650 Owners Manual - Page 56
Replacing the lamp
View all LG BG650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
56 MAINTENANCE Replacing the lamp 1 Turn off the projector and unplug the power cable from the outlet and place it on a table or a flat surface. - Allow the lamp to cool down for 1 hour before removing the used lamp from the projector because it is very hot. 2 Unscrew the screw fixing the lamp cover using a screw driver or its equivalent. After removing the screws, slide out the lamp cover.  Lamp cover fixing screw 3 After opening the lamp cover, un- screw the 3 screws that fix the lamp using a screw driver or its equivalent.   4 Slide out the fixed lamp from the hitch part. 5 Hold the lamp and pull it out slowly to remove the lamp case. 6 Insert the new lamp case gently into the correct position. (Check if it is correctly positioned.) 7 Tighten the screws you removed in step 3. (Check if the lamp is securely fixed.) 8 Close the lamp cover and tighten the screw loosened in step 2 to fix the cover. - If you turn on the projector while the lamp cover is open, the lamp warning indicator will blink in green and the projector will not be turned on. NOTE yyMake sure to use the same type of lamp for replacement. If the lamp cover is not closed correctly, the projector will not be turned on. In this case, check if the lamp is correctly fixed and contact the LG Electronics Service Center. Screw