LG DLGX2902V Owner's Manual - Page 24
LG DLGX2902V Manual
View all LG DLGX2902V manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
FLOW CHECk (DUCT CONDITION TEST) Your dryer features FlowSense TM , an innovative sensing system that automatically detects blockages and restrictions in dryer ductwork. Keeping ductwork clean of lint buildup and free of restrictions allows clothes to dry faster and reduces energy use. NOTE: When the dryer is first installed, this test should be performed to alert you to any existing problems with the exhaust duct in your home. However, since the test performed during normal operation provides more accurate information on the condition of the exhaust duct than does the installation test, the number of bars displayed during the two tests may not be the same. Correct Venting To activate the flow check (Duct condition test) : NOTE: Dryer heating test must be performed before proceeding. Then perform the duct condition test below: 1 Press and hold the DAMP DRY BEEP and TEMP. CONTROL buttons at the same time. While holding these buttons, press POWER ON/OFF. Restricted or Blocked Airflow Avoid long runs or runs with multiple elbows or bends. 2 The dryer will show lnS in the number display to indicate that it is in duct condition testing mode. 3 Press START/PAUSE. The dryer will run for approximately 2 minutes to test for blockages or restrictions to air flow in the ductwork. If no bars are shown in the display, the ductwork is free from blockages or restrictions. If all bars are lit, the dryer ductwork has a blockage that needs to be removed immediately. Check for blockages and lint buildup. FLOW SENSE FLOW SENSE FLOW SENSE FLOW SENSE Make sure the ductwork is not crushed or restricted. IMPORTANT: Do NOT interrrupt the test cycle! 24