LG DLGX7188RM Owner's Manual (English) - Page 31

HOW TO USE CUSTOM PROGRAM If you have a special combination of settings that you use frequently, you can save these settings as a CUSTOM PROGRAM. * To Save a Custom Program: 1 Turn on the dryer and turn the cycle selector knob to select the desired cycle. 2 Use the cycle setting buttons to adjust the settings for that cycle. 3 Press the cycle option button(s) for the option you would like to add. A confirmation message will be shown in the display. 4 Press and hold the CUSTOM PROGRAM button for 3 seconds. NOTE: You may only save one custom program at a time. Pressing and holding the CUSTOM PROGRAM button will overwrite any previously saved custom program. To Recall a Custom Program: 1 Turn on the dryer. 2 Press the CUSTOM PROGRAM button. 3 Press the START/PAUSE button to start the cycle. BEFORE USING THE STEAM FUNCTIONS To Fill the Steam Feeder 1 Pull out the drawer. Drawer 3 Fill the steam feeder to MAX with water. Water Steam Feeder ONLY MAX 2 Lift out the steam feeder. 4 Place the steam feeder in the drawer, then push in the drawer until it clicks into place. IMPORTANT NOTES ABOUT STEAM CYCLES • Only use water. Do not fill the steam feeder with foreign substances, rinse agents, or detergents. • Before using a Steam Cycle, the steam feeder must be filled with water up to the MAX line. If not, the ADD WATER light will blink. Make sure that the steam feeder is filled with water or the drawer is fully closed. Turn the dryer off then restart the Steam Cycle. • Before moving the dryer, make sure the steam feeder is empty. • Do not use distilled water; the water level sensor in the steam generator will not work. wWARNING: • Do not fill the steam feeder with liquids such as gasoline, dry-cleaning solvents, or other flammable or explosive substances. They give off vapors that could explode. • Do not fill the steam feeder with hot water (over 86° F / 30° C). • Do not drink water from the steam feeder. 31