LG DX630 Owners Manual - Page 40
How to attach the lens cap to the projector
View all LG DX630 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Information Regarding the projector lamp control WARNING G Don't turn off the projector at least 5 minutes after activating it. - The frequent On/Off changes may cause the lamp to deteriorate. G Don't pull out the power cord while operating the projector or the cooling fan. - It will shorten the life of the lamp or damage it. G The life-span of the projector depends on the user's environment and treatment conditions. G The projector uses a high pressure mercury lamp. Use caution when handling. The lamp can shatter and cause harm. G If you continue to use the projector after the lamp timer has recommended replacing the lamp, the lamp could shatter and be difficult and dangerous to remove. G Do the following if the lamp shatters - Unplug the projector immediately. - Let some fresh air in immediately (Ventilation). - Have service center check the projector for damage and replace the lamp. - Don't try to disassemble the projector. How to attach the lens cap to the projector 1 Find the lens cap and the strap that were supplied as accessories. 2 Insert the non-knot end of the strap into the hole at the bottom of the lens section of the projector. Attach the strap at the hole of the projector into the 3 hole of the lens cap, and then pass the lens cap through the strap lasso. 4 The strap and cap should like the picture below. 40