LG HS200G Owners Manual - Page 4
Safety Instructions - manual
View all LG HS200G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Safety Instructions Safety Instructions Please take note of the safety instructions to prevent any potential accident or misuse of the projector. ● Safety Instructions are given in two forms as detailed below. WARNING : The violation of this instruction may cause serious injuries and even death. NOTES : The violation of this instruction may cause light injuries or damage to the projector. ● After reading this manual, keep it in the place that the user can access easily. Indoor Installation WARNING Do not place the Projector in direct sunlight or near heat sources such as radiators, fires and stove etc. This may cause a fire hazard ! Do not place inflammable materials beside the projector This may cause a fire hazard ! Do not allow children to hang on the installed projector. It may cause the projector to fall, causing injury or death. Indoor Installation NOTES Disconnect from the power and remove all connections before moving. Do not place the projector close to sources of steam or oil such as a humidifier. This may create a fire hazard or an electric shock hazard! When installing the projector on a table, be careful not to place it near the edge. The projector could fall causing serious injury to a child or adult and serious damage to the projector. Only use a suitable stand. Only use the projector on a level and stable surface. It may fall and cause injury and/or damage to the unit. Do not place the projector where it might be exposed to dust. This may cause a fire hazard or damage to the unit! Ensure good ventilation around the projector. The distance between the projector and the wall should be more than 30cm/12 inches. An excessive increase in its internal temperature may cause a fire hazard or damage to the unit! Do not block the vents of the projector or restrict air-flow in any way. This would cause the internal temperature to increase and could cause a fire hazard or damage to the unit! Do not place the projector directly on a carpet, rug or place where ventilation is restricted. This would cause its internal temperature to increase and might create a fire hazard or damage the unit. Do not use the projector in a damp place such as a bathroom where it is likely to get wet. This may cause a fire or an electric shock hazard ! Power WARNING Earth wire should be connected. The third-prong ground wire should always be connected properly. If the earth wire is not connected, there is a possiible danger of electic shock caused or fire. Never by pass the safety features of the ground wire. Do not connect the ground to telephone wires, lightning rods, or gas pipes. The power cord should be inserted fully into the power outlet to avoid a fire hazard! This may cause a fire hazard or damage the unit. Do not place heavy objects on the power cord. This may cause a fire or an electric shock hazard ! 5