LG L26W56S Operation Guide - Page 9

Antenna Hookup Connect an off-air antenna to the LCD TV/Monitor. 1 Locate the Antenna/Cable jack on the back of the LCD TV/Monitor. 2 Connect the antenna wire (Flat or Round) that runs from the wall to this jack, according to one of the diagrams shown to the right. 3 After all connections are complete, plug in the TV. The LCD TV/Monitor is designed to operate on AC power. COMPONENT(DVD/DTV)1 AUDIO IN VIDEO IN Flat Wire (300 ohm) AUDIO IN VIDEO IN COMPONENT(DVD/DTV)2 Connections Panel If the antenna is a 75 ohm RF cable, then no adapters are required. A 300 to 75 ohm adapter is not included with the Zenith LCD TV/Monitor. 300/75 ohm Adapter COMPONENT(DVD/DTV)1 AUDIO IN VIDEO IN AUDIO IN VIDEO IN COMPONENT(DVD/DTV)2 Connections Panel RF Coaxial Wire (75 ohm) ANTENNA CABLE M.P.I ANTENNA CABLE M.P.I RJP INTERFACE FUTURE USE RJP INTERFACE FUTURE USE Mini glossary 75 OHM RF CABLE 300 TO 75 OHM ADAPTER The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire sticking through the middle, and it screws onto the threaded jack on the back of the TV. A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws on one end and a round opening with a wire sticking out on the other end. PAGE 9