LG LBC20514SW Owner's Manual - Page 12

REFRIGERATOR INSTALLATION HOW TO REMOVE AND INSTALL THE PULL OUT • With both hands, hold the center of the bar and push DRAWER it in so that it is fit to both rails simultaneously. IMPORTANT: To avoid possible injury or damage to the product or your property, please use two people to perform the following instructions: 1. Removing the Pull Out Drawer • Pull the drawer out to maximum extension. Remove the bottom rack (1) by tilting it back a little and then lifting it off the railing tracks. 1 CAUTION: When removing the drawer, do not hold the handle. If it comes off, it could cause personal injury. CAUTION: To place the drawer on the floor, take care not to damage the floor or hurt your feet with the sharp edges on the side with the hinges. • Put pressure on the two hangers (2) with your thumbs in order to lift it up. • Separate the left and right rail cover. 2. Installing the Pull Out Drawer • With both hands, hold the center of the bar and pull it outward so that the two rails extend out at the same time. 2 • Remove the screws (3) from both sides of the rail track. 3 • Mount door supports (1) into the tabs on the railing track (2), starting in the back first and then connecting the part in the front last, as shown in the figure. 1 2 • With both hands, hold both sides of the door and pull up to separate it. • Push the drawer down into position and tighten the screws (3). 3 11