LG LDCS24223S Owners Manual - Page 13
Choosing the Proper Location, Unpacking Your Refrigerator
View all LG LDCS24223S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ENGLISH ENGLISH Unpacking Your Refrigerator DANGER . Use two or more people to move and install the refrigerator. Failure to do so can result in back or other injury. . Your refrigerator is heavy. When moving the refrigerator for cleaning or service, the refrigerator straight out when moving it. Do not wiggle or walk the refrigerator could occur. . such as gasoline, away from the refrigerator. Failure to do so can result in Remove tape and any temporary labels from your refrigerator before using. Do not remove any warning-type labels, the model and serial number label, Installations labels or the Circuit Diagram located in the backward of refrigerator. To remove any remaining tape or glue, rub the area briskly with your thumb. Tape or glue residue can also be easily removed by rubbing a small amount of liquid dish soap over the adhesive with your gers. Wipe with warm water and dry. Do not use sharp instruments, rubbing alcohol, ammabl uids, or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. Refrigerator shelves are installed in the shipping position. Please reinstall shelves according to your individual storage needs. INSTALLATION 12 Choosing the Proper Location . Select a place where a water supply can be easily connected for the automatic icemaker. NOTE The water pressure must be between 20 and 120 psi (0,138 - 0,82 MPa) on models 120 psi (0,276 - 0,82 MPa) on models with a . The refrigerator should always be plugged into its own individual properly grounded electrical outlet rated for 115/127 V ~ 60 Hz, AC only, and fused at 15 A. This provides the best performance and also prevents overloading house hazard from overheated wires. It is recommended that a separate circuit serving only this appliance be provided. CAUTION To reduce the risk of electric shock, do not install the refrigerator in a wet or damp area. Flooring To avoid noise and vibration, the unit must be leveled and installed on a solidly constructed front should be slightly higher than the rear to aid in door closing. The leveling legs can be turned easily by tipping the cabinet slightly. Turn the leveling legs to the left to raise the unit or to the right to lower it. (See Leveling and Door Alignment.) NOTE Installing on carpeting, soft tile surfaces, a platform or weakly supported structure is not recommended.