LG LDCS24223S Owners Manual - Page 15

INSTALLATION 14 ENGLISH ENGLISH Removing/Assembling the Freezer Drawer Handle (On Freezer Drawer Models) Removing the Handle Removing/Assembling the Doors and Drawers When it is necessary to move the refrigerator through a narrow opening, removing the doors is the recommended procedure. 1 Loosen the set screws located on the lower side of the handle with a 3/32 in. (2.5 mm) Allen wrench and remove the handle. 2 Loosen the mounting fasteners that connect to the freezer drawer and handle using a 1/4 in. (6.35 mm) Allen wrench, and remove the mounting fasteners. Assembling the Handle 1 Assemble the mounting fasteners at both ends of the handle using a 1/4 in. (6.35 mm) Allen wrench. CAUTION . If your entrance door is too narrow for the refrigerator to pass through, remove the refrigerator doors and move the refrigerator sideways through the doorway. . Use two or more people to remove and install the refrigerator doors. Failure to do so can result in back or other injury. . Disconnect the electrical supply to the refrigerator before installation. Failure to do so could result in serious injury or death. . Do not put hands, feet or other objects into the air vents or bottom of the refrigerator. You may be injured or receive an electrical shock. . Be careful when handling the hinge and stopper. You may be injured. . Remove food and bins before detaching the doors and drawers. 2 Place the handle on the door by fitting the handle footprints over the mounting fasteners and tightening the set screws with a 3/32 in. (2.5 mm) Allen wrench. CAUTION When assembling or disassembling the handles: . Grasp the handle tightly to avoid dropping it. . Do not swing the handle into nearby people or animals. . Make sure that the bracket hole of the handle fits properly into the stopper bolt of the door. Assemble the set screws to fix the handle into place. . Make sure that there is not a gap between the door and handle after assembling the handle.