LG LDP7808BD Owners Manual - Page 56

ENGLISH TROUBLESHOOTING 55 Problem Dishwasher chimes if panel is touched during operation. Dishwasher did not finish cycle. Leaking in front of unit Possible Cause & Solution Bumping into or touching the control panel during operation may result in a disabled button sound. Only the Power, Start, and Control Lock buttons are enabled during operation to prevent cycle settings from being changed inadvertently. ••Button sounds can be turned off by pressing and holding Half Load for three seconds. ••The end of cycle chime and safety alert sounds will still sound. Door was opened during cycle. ••If the door is opened during a cycle, the Start key must be pressed within 4 minutes or the machine turns off and all settings are lost. Dishwasher not leveled properly. ••Verify the unit is level from side to side and from front to back. See leveling instructions in the Installation section. Wrong detergent used. ••If excessive sudsing is causing the leak, allow the foam to subside for 24 hours then clean the inside of the tub with milk. The password for the Wi-Fi that you are trying to connect to is incorrect. ••Find the Wi-Fi network connected to your smartphone and remove it, then register your appliance on LG ThinQ. Mobile data for your smartphone is turned on. ••Turn off the Mobile data of your smartphone and register the appliance using the Wi-Fi network. Your home appliance and smartphone is not connected to the Wi-Fi network. The wireless network name (SSID) is set incorrectly. ••The wireless network name (SSID) should be a combination of English letters and numbers. (Do not use special characters.) The router frequency is not 2.4 GHz. ••Only a 2.4 GHz router frequency is supported. Set the wireless router to 2.4 GHz and connect the appliance to the wireless router. To check the router frequency, check with your Internet service provider or the router manufacturer. The distance between the appliance and the router is too far. ••If the distance between the appliance and the router is too far, the signal may be weak and the connection may not be configured correctly. Move the location of the router so that it is closer to the appliance. P1, P2, P3, or P4 appears in display. n:#, U:#, d:#, t# appearsin display. (# = a number) L0, L1, L2, L3 or L4 appears in display. CL appears in display. The Download cycle is selected. ••This is not an error code. This code indicates the current Download cycle. Test mode is selected. ••This is not an error code. This code is used when testing the dishwasher. Power the unit off and on and the code will disappear. Rinse Aid Level setting mode is selected. ••This is not an error code. This code indicates the current rinse aid level. For more information, refer to the Adding Cleaning Agents section. Control Lock is activated. ••This is not an error code. This code indicates that the control lock is activated. Press and hold Half Load and Energy Saver simultaneously for three seconds.