LG LFX25960SW User Guide - Page 34

The Water, Shutoff Valve - water line

Get LG LFX25960SW PDF manuals and user guides View all LG LFX25960SW manuals
Add to My Manuals
Save this manual to your list of manuals

Page 34 highlights

, CONNECT THE TUBING TO THE REFRIGERATOR Removing and Replacing Valve Cover NOTE: Before making the connection to the refrigerator, be sure the refrigerator power cord is not plugged into the wall outlet. 1. Place a compression nut and a ferrule(sleeve) onto the end of tubing. 10.TURN THE WATER ON AT THE SHUTOFF VALVE Tighten any connections that leak. Reattach the compressor compartment access cover. Compression Nut Ferrule (sleeve) 2. Insert the tube into the valve and fasten with wrench as shown in the figure below. © [_ Tubing 11. PLUG IN THE REFRIGERATOR Arrange the coil of tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall. j A CAUTION: Check to see if water dripping occurs at water line connections. NOTE: Water valve connector SVC guide When separating the connector which is connected in the Valve, press the portion of _ and pull the connector with finger as shown in the the picture 12. START THE ICEMAKER Set the icemaker power switch to the ON position. The icemaker will not begin to operate until it reaches its operating temperature of 15°F (-9°C) or below. It will then begin operation automatically if the icemaker power switch is in the I (on) position. 34

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
,
CONNECT
THE TUBING
TO THE
REFRIGERATOR
Removing
and Replacing
Valve Cover
NOTE:
Before making the connection
to the
refrigerator,
be sure the refrigerator
power cord is not
plugged
into the wall outlet.
1. Place a compression
nut and a ferrule(sleeve)
onto
the end of tubing.
Compression
Nut
Ferrule (sleeve)
10.TURN
THE WATER
ON AT
THE
SHUTOFF VALVE
Tighten any connections
that leak.
Reattach
the compressor
compartment
access cover.
2.
Insert the tube into the valve and fasten with wrench
as shown in the figure below.
©
[_
j
Tubing
11. PLUG
IN THE
REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refrigerator
or against the wall.
Push the refrigerator
back to the wall.
A
CAUTION:
Check
to see if water dripping occurs
at
water line connections.
NOTE: Water valve connector
SVC guide When
separating
the connector
which is connected
in the
Valve, press the portion of _ and pull the connector
with finger as shown
in the the picture
12.
START
THE
ICEMAKER
Set the icemaker
power switch to the ON position.
The icemaker
will not begin to operate until it reaches
its operating temperature
of 15°F (-9°C)
or below. It
will then begin operation automatically
if the icemaker
power switch is in the I (on) position.
34