LG LMV1831BD INSTALLATION - Page 15

STEP 6: Attach The Oven To The Wall wW A R N I N G To avoid risk of personal injury or property damage, you will need two people to install this microwave oven. 1. Carefully lift microwave oven and hang it on support tabs (See Figure 28) at the bottom of the mounting plate.Reaching through upper cabinet, thread power supply cord through the power supply cord hole in the bottom of the upper cabinet. See Figure 30. 2. Rotate the microwave oven upward so the top of oven is against the bottom of the upper cabinet or cabinet frame. 3. Then insert a bolt down through each hole in the upper cabinet bottom.See Figure 31. Tighten the bolts until the gap between the upper cabinet and microwave oven is closed. 4. If wall-vented or room-vented installation is used,go to No. 7 on the next page. 5. Roof venting installation: See Figure 32. Install ductwork through the vent opening in the upper cabinet. Complete the venting system through the roof according to the method needed. See Prepare The Venting System STEP 2. Use caulking gun to seal the exterior roof opening around the exhaust cap. See Figure 7 on page 8. 6. Use the power supply cord clamp to bundle the power supply cord. Install the power supply cord clamp, using a screw as shown in Figure 33, to inside of the cabinet. 7. Grasp filter screen with one hand holding the ring and the other hand holding the opposite end. Insert the end of the filter screen without ring into the opening and slide towards the side of the microwave oven. Insert ring end of filter screen into the opening and slide entire screen towards the center of the microwave until screen is securely in position. Repeat for other filter screen. See Figure 34. 8. Plug in the power supply cord. 9. Read your Owner's Manual, then check the operation of your microwave oven. Power Cord Power Cord Hole Figure 30 Figure 31 Damper Figure 32 Figure 33 Power supply Cord Clamp - 15 - Figure 34