LG LMV1831BD INSTALLATION - Page 9

STEP 3: Prepare The Venting Blower Your microwave oven is shipped with the blower assembled for room-vented. You need to adjust the blower if you want wall-vented or roof-vented installation. wW A R N I N G ELECTRICAL SHOCK HAZARD! UNPLUG UNIT BEFORE WORKING ON IT. • DO NOT PULL OR STRETCH THE BLOWER WIRING! Pulling and stretching the blower wiring could result in electrical shock. 1. Remove any shipping materials and parts from inside the microwave oven. Set them aside for later use. 2. Cover the counter top or cooktop with a thick, protective covering to protect it from damage and dirt. See Figure 11. NOTE: If you have a free-standing range, disconnect it, move it onto a piece of cardboard or hardboard and pull it away from the wall, so that you can get closer to the upper cabinet and back wall for easier measuring and drilling. 3. Locate exhaust adaptor, grease filters and hardware packet. 4. At this point, remove any adhesive tape (if there is any), on the exhaust adaptor, the grease filters and the power supply cord. A thick, protective covering Figure 11 ROOM-VENTED INSTALLATION: This oven is shipped assembled for room-vented. You need to go to STEP 4: PREPARE THE WALL & UPPER CABINET located on page 13 . wW A R N I N G ),5(+$=$5'&255(&7/