LG LRE30755SW Owner's Manual (English) - Page 27
Maintenance
View all LG LRE30755SW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
MAINTENANCE REMOVING &REPLACING THE WARMING DRAWER To Remove Warming Drawer: 1. CAUTION - Turn power OFF before removing the Warming Drawer. 2. Open the drawer to the fully opened position. 3. Remove the 2 screws (right and left sides). (refer to the drowing below) 4. Locate glide lever on each side of drawer, push down on the left glide lever and pull up on the right glide lever. 5. Pull the Warming Drawer away from the range. Remove screw To Replace the Warming Drawer: 1. Replace shield on the right glide of the drawer body. 2. Pull the bearing glides to the front of the chassis glide. 3. Align the glide on each side of the drawer with the glide slots on the range. 4. Push the drawer into the range until levers click (approximately 2 inches). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers click or the bearing glides do not feel seated, remove the drawer and repeat steps 2-4. This will minimize possible damage to the bearing glides. OVEN VENT The oven vent is located above the left rear surface unit. This area could become hot during oven use. It is normal for steam to come out of the vent. The vent is important for proper air circulation. Never block this vent. Lever Lever Push down with finger Pull up with finger English Español - 27 -