LG LSC24971ST Owner's Manual - Page 12

Door removal

Page 12 highlights

Installation ENGLISH Door removal WARNING Remove lower cover and then feed water tube Remove the freezer compartment door Electric Shock Hazard Disconnect electrical supply to refrigerator before installing. Failure to do so could result in death or serious injury. If your access door is too narrow for the Feed water tube refrigerator to pass through, remove the refrigerator door and pass the refrigerator laterally. Lower cover Remove 2 screws holding the lower cover in place. Pull up the feed water tube while pressing area shown in the figure to the right. NOTE • If a tube end is deformed or abraded, cut the part away. 1) Removing the hinge cover by loosening Hinge the screws. Separate all connection wires cover Connection wires except for the earth line after. Upper hinge 2) Remove the keeper by rotating it counter clockwise ( ) and then lifting the upper hinge up ( ). Keeper Ground Line Upper hinge NOTE • When removing the upper hinge, be careful that the door does not fall forwards . 3) Remove the freezer compartment door by lifting it upward. This time, the door should be lifted enough for the feed water pipe tube to be completely pulled out. Lower hinge NOTE • Move the refrigerator compartment door passing through the access door and lay it down, but be careful not to damage the feed water pipe tube. Remove the refrigerator door 1) Loosen the hinge cover screws and remove the cover. Remove connection wire, if any, except for the earth line. Connection wires Upper hinge 2) Remove keeper by rotating it clockwise ( ) and then remove the upper hinge by lifting it up ( ). Keeper 3) Remove the refrigerator compartment door by lifting it up. 12 Lower hinge

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43

12
ENGLISH
Installation
Door removal
Electric Shock Hazard
Disconnect electrical supply to refrigerator before
installing. Failure to do so could result in death or
serious injury.
If your access door is too narrow for the
refrigerator to pass through, remove the refrigerator door and pass the
refrigerator laterally.
Remove 2 screws holding the lower cover in place. Pull up the feed water tube while
pressing area
±
shown in the figure to the right.
Remove lower
cover and
then feed water
tube
Remove the
freezer
compartment
door
Remove the
refrigerator
door
1) Removing the hinge cover by loosening
the screws. Separate all connection wires
except for the earth line after.
2) Remove the keeper by rotating it counter
clockwise (
±
) and then lifting the upper
hinge up (
²
).
3) Remove the freezer compartment door by lifting
it upward. This time, the door should be lifted
enough for the feed water pipe tube to be
completely pulled out.
1) Loosen the hinge cover screws and
remove the cover. Remove connection
wire, if any, except for the earth line.
2) Remove keeper by rotating it clockwise
(
±
) and then remove the upper hinge
by lifting it up (
²
).
3) Remove the refrigerator compartment
door by lifting it up.
If a tube end is deformed or abraded, cut the part away.
NOTE
When removing the upper hinge, be careful that
the door does not fall forwards .
NOTE
Move the refrigerator compartment door passing through the access door and lay
it down, but be careful not to damage the feed water pipe tube.
NOTE
Lower cover
Lower hinge
Lower hinge
Keeper
Feed water tube
Connection
wires
Hinge
cover
Upper hinge
Keeper
Upper hinge
Ground Line
Upper hinge
Connection
wires
WARNING