LG LSD4913ST Owners Manual - Page 19
Connecting Electricity
View all LG LSD4913ST manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Connecting Electricity Electrical Requirements This appliance must be installed and grounded on a branch circuit by a qualified technician in accordance with the National Electrical code ANSI/NFPA NO. 70 latest edition. All wiring should conform to Local and NEC codes. This range requires a single-phase, 3 wire, A.C 120/208 V or 120/240 V 60 Hz electrical system. Use only a 3-conductor or a 4-conductor UL - listed range cord with closed-loop terminals, open-end spade lugs with upturned ends or similar termination. Do not install the power cord without a strain relief. A range cord rated at 40 amps with 120/240 minimum volt range is required. If a 50 amp range cord is used, it should be marked for use with 13/8" diameter connection openings. This appliance may be connected by means of a conduit or power cord. If a conduit is being used, go to page 21 for 3 wire conduit connections or 4 wire conduit connections. Warning •• Allow 2 to 3 ft (61.0 cm to 91.4 cm) of slack in the line so that the range can be moved if servicing is ever necessary. •• The power supply cord and plug should not be modified. If it will not fit the outlet, have a proper outlet Installed by a qualified electrician. •• Using an extension cord to connect the power is prohibited. Connect the power cord and plug directly. •• Electrical ground is required on this appliance. •• Make sure that the power cord is not pinched by the range or heavy objects. Failure to do so can result in serious burns or electrical shock. Specified power-supply-cord kit rating Range rating, watts 120/240 volts 3-wire 120/208 volts 3-wire Specified rating of power supplycord kit, amperes Diameter (inches) of Range connection Opening Power cord Conduit 8,750 - 7,801 - 40 or 50A 1 3/8" 16,500 12,500 1 1/8" 16,501 - 12,501 - 50 22,500 18,500 1 3/4" 1 3/8" 3, 4 - Wire electrical wall Receptacle 4 Wire receptacle (14-50R) 3 Wire receptacle (10-50R) INSTALLATION 19 Connecting the Power Cord The rear access cover must be removed. Loosen the two screws with a screwdriver. The terminal block will then be accessible. Access cover Use the cord/conduit connection plate to install the power cord or conduit. Leave the connection plate as installed for power cord installations. Remove the connection plate for conduit installations and use the smaller 11/8 in. (2.8 cm) conduit hole instead of the 13/8 in. (3.5 cm) power cord hole. 11/8" (2.8 cm) Conduit 13/8" (3.5 cm) Cord Remove the conduit connection plate For power cord installations, hook the strain relief over the 13/8 in. (3.5 cm) power cord hole located below the rear of the oven. Insert the power cord through the strain relief and tighten it. Conduit connection plate Power cord Assembling power cord strain relief at the 13/8" opening For conduit installations, insert the conduit strain relief in the 11/8 in. (2.8 cm) conduit hole. Then install the conduit through the body of the strain relief and fasten the strain relief with its ring. Ring Cord/ Conduit connection plate Body Conduit Assembling conduit cord strain relief at the 11/8" opening ENGLISH