LG LSRG309ST Owner's Manual - Page 43

Removable Warming Drawer

Page 43 highlights

ENGLISH CARE AND CLEANING OF THE RANGE REMOVABLE WARMING DRAWER NOTE: Before performing any adjustments, cleaning or service, unplug the range. Make sure the warming drawer heating element is cool. Most cleaning can be done with the drawer in place. However, the drawer may be removed if further cleaning is needed. Use soap and warm water to thoroughly clean. Remove screw TO REMOVE THE DRAWER: ᕡ Open the drawer to the fully opened position. ᕢ Remove the 2 screws (right and left sides). (refer to the illustration as below) ᕣ Locate glide lever on each side of drawer, push down on the left glide lever and pull up on the right glide lever. ᕤ Pull the Warming Drawer away from the range. Lever Push down with finger Lever Pull up with finger TO REPLACE THE DRAWER: ᕡ Pull the bearing glides to the front of the chassis glide. ᕢ Align the glide on each side of the drawer with the glide slots on the range. ᕣ Push the drawer into the range until levers "click" (approximately 2 inch). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 2-4. This will minimize possible damage to the bearing glides. ᕤ Replace the two screws. 43

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49

CARE AND CLEANING OF THE RANGE
43
ENGLISH
REMOVABLE WARMING DRAWER
NOTE:
Before performing any adjustments, cleaning
or service, unplug the range.
Make sure the warming drawer heating element is
cool.
Most cleaning can be done with the drawer in place.
However, the drawer may be removed if further
cleaning is needed. Use soap and warm water to
thoroughly clean.
TO REMOVE THE DRAWER:
±
Open the drawer to the fully opened position.
²
Remove the 2 screws (right and left sides). (refer
to the illustration as below)
³
Locate glide lever on each side of drawer, push
down on the left glide lever and pull up on the right
glide lever.
´
Pull the Warming Drawer away from the range.
TO REPLACE THE DRAWER:
±
Pull the bearing glides to the front of the chassis
glide.
²
Align the glide on each side of the drawer with the
glide slots on the range.
³
Push the drawer into the range until levers “click”
(approximately 2 inch). Pull the drawer open again
to seat bearing glides into position.
If you do not hear the levers “click” or the
bearing glides do not feel seated remove the
drawer and repeat steps 2-4.
This will minimize possible damage to the bearing
glides.
´
Replace the two screws.
Push down with finger
Lever
Pull up with finger
Lever
Remove screw