LG LST3410A Owners Manual - Page 66

HD DVR Quick Setup Guide _ 2 STEP 1 Unpack and Connect 2-2. If your TV does not have "COMPONENT (YPbPr) IN" jacks: (Fig. 2) Connect the "A/V OUT" jacks from the HD DVR to the "VIDEO IN" and "AUDIO IN" jacks on your TV using RCA-type cables. If your TV is equipped with an S-Video jack, you can use the "S-VIDEO OUT" jack. Connect with an S-VIDEO cable (not included). Fig. 2 TV Connection Panel HD DVR Quick Setup Guide _ 3 Antenna HD DVR Connection Panel 1. Unpack the HD DVR and Accessories Make sure you have received all the accessories listed below with the HD DVR. (see page 10 of the owner's manual.) - HD DVR - RF Cable - Audio Cable - Video (Composite) Cable - Component (YPbPr) Cable - G-LINK® Cable - Demo Pin (Located in the G-LINK port of the HD DVR) - DVI Cable - Remote Control - Batteries (size AA) 3. Connect "Antenna" to the HD DVR 4. Plug in power cord 5. Tune TV(if necessary) to see Auto Demo Connect the "Antenna" to the "ANT IN" jack on the HD DVR using a coaxial RF cable. Note: You can skip this step if you don't want to watch terrestrial broadcasting. Turn on your TV and the HD DVR (press POWER on the remote control for the HD DVR). 2. Connect the HD DVR to your TV 2-1. If your TV has "COMPONENT (YPbPr) IN" jacks: (Fig. 1) Connect the "COMPONENT OUT" jacks from the HD DVR to the "COMPONENT IN" jacks on your TV using component video cables. Connect the L/R "AUDIO OUT" jacks on the HD DVR to the L/R "AUDIO IN" jacks on your TV using RCA-type cables. If your TV is equipped with a "Digital Audio Input (Optical)" jack, you can use "DIGITAL AUDIO (OPTICAL OUT)" jack. Connect with an optical audio cable (not included). If you do not see Auto Demo, change input source of your TV or resolution/output of the HD DVR(see "Changing Resolution/Output"). Note: While you are watching Auto Demo, you can see HD television if the HD DVR is connected to an HDTV. Output Indicator Resolution Indicator HD DVR Front Control Panel Fig. 1 HD Monitor Connection Panel DISPLAY FORMAT: Changes blinking indicator SELECT: Chooses currently blinking resolution or output Changing Resolution/Output Press DISPLAY FORMAT on the front panel repeatedly to change output (DVI, RGB, YPbPr, or Video) afterward press SELECT. And then press DISPLAY FORMAT repeatedly again to change resolution (1080i, 720p, 480p, 480i, NATIVE, VARIABLE 1, VARIABLE 2, VARIABLE 3, or AUTO DVI) afterward press SELECT. Antenna HD DVR Connection Panel 6. Turn off the HD DVR. 7. Unplug the power cord and wait 5 seconds. 8. Remove "Demo Pin". 9. Plug in the power cord and turn on th the HDDVR.