LG LTC22350ST Owner's Manual (English) - Page 11

REFRIGERATOR INSTALLATION 3. Attaching Refrigerator Door Attach the base grille (1). Remove screw (2) from left side to right side. Attach the door (3) to the bottom hinge pin. Attach the middle hinge (4) on the opposite side with the 3 screws (5). 4. Attaching Freezer Door Place the door (8) onto the middle hinge pin (7). Attach the top hinge (10) with 3 screws. Reinstall top hinge cover (11). DOOR CLOSING AND ALIGNMENT Door Closing Your refrigerator has two front leveling screws__one on the right and one on the left. If your refrigerator seems unsteady or you want the doors to close easier, adjust the Refrigerator's tilt using the instructions below: 1. Plug refrigerator power cord into a 3-prong grounded outlet. Move the refrigerator into its final position. 2. Remove the base grille by pulling it straight out. The two leveling screws are located at the bottom of the refrigerator on either side. 3. Insert a flat screwdriver in slots to adjust the leveling screws.Turn the leveling screw clockwise to raise that side of the refrigerator or counterclockwise to lower it. It may take several turns of the leveling screw to adjust the tilt of the refrigerator. NOTE: Having someone push against the top of the refrigerator takes some weight off the leveling screws. This makes it easier to adjust the screws. 5. After Completing the Job Make sure that the four corners of the door gasket are not folded over. To ensure a good seal, apply a small amount of silicon grease on the corner gaskets. Corner 4. Open both doors again and check to make sure that they close easily. If not, tilt the refrigerator slightly more to the rear by turning both leveling screws clockwise. It may take several more turns, and you should turn both leveling screws the same amount. 5. Replace the base grille. Door Alignment If the space between your doors is uneven, follow the instructions below to align the doors: 1. Pry off the top hinge cover. 2. Loosen the top hinge screws using a 10mm socket or wrench. 3. Have someone hold the door in place or put a spacer between the doors while you tighten the top hinge screws. 4. Replace the top hinge cover. 11