LG M2404ER Service Manual - Page 9

2.3.4 POWER CORD 1. Remove the control box. (Refer to section 2.1.3) 2. Unfold the control box. (Refer to section 2.3.3) 3. Disconnect the grounding screw from the Base pan. 4. Disconnect 2 receptacles. 5. Remove a screw which fastens the clip cord. 6. Pull the power cord. (See Fig. 13) 7. Re-install the components by referring to the removal procedure, above. (Use only one ground-marked hole, , for ground connection.) 8. If the supply cord of this appliance is damaged, it must be replaced with the factory-authorized and specified cord. Figure 13 2.3.5 THERMISTOR 1. Remove the control box. (Refer to section 2.1.3) 2. Unfold the control box. (Refer to section 2.3.3) 3. Disconnect all the leads of thermistor terminals. 4. Remove the thermistor. (See Fig. 14) 5. Re-install the components by referring to the removal procedures, above. Figure 14 Copyright ©2007 LG Electronics. Inc. All right reserved. Only for training and service purposes -9- LGE Internal Use Only